Central Heating Air Vent Location

In this case their height will be determined by your system.

Central heating air vent location. Try to avoid doing this to your vents as it will reduce their efficiency. The return vent pulls cold air from the bottom of the room and returns it to the furnace to be reheated and returned as warm air. Unlike supply vents return vents do not need to be cased in metal. Some systems have two sets of return vents one up high for warm air and one low to the floor for cool air.

The supply vents which push air through the duct work must be placed properly. The best location of the return vents depends on whether the system is heating or cooling the air. Many have duct work in crawlspaces so the registers are placed in the floor. The low vents stay closed in the summer and the high vents stay closed in the winter.

Place your cold air return vents on the inside walls of buildings at the lowest point. Re best location of airbottle vent in central heating system i have a potterton boiler 60e connected to megaflow in the loft with bottled airvent in the flow and also in the return pipe in the loft near the megaflow tank the boiler is located on the ground floor in the garage with grundig pump. Ducts should always be located within the conditioned envelope of the building ideally within the framing of floors ceilings and walls and they should be maintained so air does not leak out of. Whether you need an air conditioner installation a heater repair or general hvac maintenance our comfort specialists will complete the job to a high standard.

If it s cooling the return vents should be near the ceiling where the warm air collects but if. Attic systems may use registers placed in the ceiling instead.