Ceiling Fan Remote Not Working Troubleshooting

The dip switches need to match each other in order for them to be on the same frequency and work properly.

Ceiling fan remote not working troubleshooting. Remotes can stop working for a variety of reasons. In terms of troubleshooting hunter ceiling fan remote controls much of the troubleshooting will be similar to troubleshooting other fans. If you are using a remote or. There would be dipswitches on in the back of the remote as well as on or in the fan canopy.

Check the batteries in your ceiling fan s remote. Yes the ceiling fan remote control module may be faulty. To start troubleshooting the dip switches on the fan you need to try changing the position of the dip switches. Make sure that the power is turned on to the fan.

Flip the switch several times to make sure it is the right. First ensure that the mains power is turned on and then check to ensure that the circuit breaker for the unit is not. The troubleshooting to try is common as it applies to different fans. Troubleshooting a remote is a more common issue as it applies to most ceiling fans not just harbor breeze ceiling fans.

Follow the steps below to determine the cause. So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan. Assuming you don t have another ceiling fan and remote to test your troublesome fan with and the remote just suddenly stopped working you may want to consider replacing both the remote and the receiver. Locate the receiver for the remote usually housed in your fan s mounting bracket and find the.

Here s how to troubleshoot a remote control that isn t working. There are some steps to try troubleshooting the remote. Confirm the reverse switch is not in a neutral position. Try using the remote to turn on the.

The easiest way to find a replacement remote with all the settings that your existing remote offered is to shop by brand. This may seem like a rudimentary or obvious thing and yes we do start. Below are troubleshooting steps to follow. If the ceiling fan and light works normally then the remote control module will need to be replaced.

Check to ensure that the problem is not with the remote see fanimation remote not working guide above if the mains supply circuit. The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high. Turn the power off to the fan at the circuit breaker box.