Ceiling Fan Remote Control Not Working

Troubleshooting a remote is a more common issue as it applies to most ceiling fans not just harbor breeze ceiling fans.

Ceiling fan remote control not working. The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high. If you are using a remote control check that the batteries are installed properly and are not dead. Kung fu maintenance shows ceiling fan not responding to remote almost threw out fan for malfunctioning nice little hand held drill http amzn to 2lixpwx get. The troubleshooting to try is common as it applies to different fans.

There are some steps to try troubleshooting the remote. If your hampton bay ceiling fan remote is not working there are some standard troubleshooting steps you can go through in order to determine the problem. Once you purchase a new remote go through the necessary steps to set it up. Ceiling fan remote controls use frequencies to transmit signals which activate the ceiling fan motor and the ceiling fan light.

Remotes can stop working for a variety of reasons. These troubleshooting steps will take you through the basic operation of the remote like checking the batteries and determining whether the remote is sending a signal or not. Turn of the unit using the remote if the power button is working press the off button on the fan for about 10 seconds wait for about another 20 seconds and then turn the fan on again using the remote this will reset the remote and deliver smooth operation. Rarely another electronic device may interfere with the ceiling fan frequencies which may prevent normal operations from occurring.

If this is the case then the receiver can be removed and replaced with another remote receiver kit or the fan can be operated as standard with the 3 speed pullchain. So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan. Usually they consist of a remote receiver wired to the fan inside the ceiling canopy and the fan will still have a pullchain that is not used.